Simple Bolt-On Installation

Designed to be as simple of an installation process as possible, no permanent modification to your sawmill is required. You can remove the system at any time and return to stock crank handle operation. For installation, simply disassemble the crank handle assembly, mount the bracket, and install associated hardware. Installation takes approximately 15 minutes!

Basic "Lift Mode"

A traditional up/down positioning mode which will adjust the saw height up or down in even set measurements. By default the display will show 1/64" increments of your movements. You can change the increment display in settings. Holding the up or down switch will provide continuous adjustment.

"Bump" Mode

Position the saw for accurate board sizes. You are able to set your desired board thickness and lower the blade to your set dimension with a single click. A single up-click will return you immediately back to zero. Bump range can be adjusted up to 6" per bump.

Slack Compensation

"Bump" Mode also offers Slack Compensation, which will accommodate cable slack that can be introduced into the cable-lift system on Woodland Mills saws. Every "Bump" move will include a configurable slack compensation move, which will lower the saw further and raise back up to your set bump increment.
Demonstration:

https://youtu.be/YwFwaUWPxPY

Kerf Compensation

Set your blade thickness and kerf will automatically be applied during bump modes. If you bump down twice for a double-thick board, the kerf will only be applied once to ensure the accuracy of the cut.

Expandable!

Want to add our Power-Feed System? Plug it in!

Want to add throttle control to our Power-Feed System? Plug it in!

Want to add the Auto-Feed Log Sensor system to our Power-Feed System? Plug it in!

Complete expandability is at your fingertips!

Field Upgradable

As more features become available, firmware updates can be performed wirelessly with a smartphone, tablet, or laptop. Don't hesitate to contact us for feature addition ideas, we're open to suggestions.

Compatibility

This is a direct bolt-on fit for HM136MAX.
Enclosure color, switch color, and faceplate are subject to change.

International Customers(non-US)

Please contact me for shipping rate concerns. Sometimes our shipping estimator will give outrageous pricing or inaccurate pricing. I would love to double-check and give you the most accurate shipping cost as possible.

Due to being hand made after ordering, please allow 6-8 weeks for shipping (as of Feb 23, 2024)
Due to being hand made after ordering, please allow 8-12 weeks for shipping (as of Jan 1, 2025)

*please be aware of your machine capabilities, we are not responsible for the derailing of your saw carriage. **Auto-Feed requires the installation of travel safety switches to be installed and power-up procedures must be completed for the system to enable. Placement of the magnetically attached log sensor will also need to be adjusted dependent on the position of the log.

PowerLIFT Installation Manual

PowerLIFT Installation Video

https://youtu.be/tdVP5ScH82o